How Can We Help?
HOW TO UNSUBSCRIBE FROM MAILING LISTS
HOW TO UNSUBSCRIBE FROM MAILING LISTS
Last Updated: 22 Oct 2001
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
*** PLEASE NOTE: Link(s), If Provided, May Be Wrapped ***
The following was generously provided by Robert Fish on
a Microsoft Exchange Mailing List. His creativity is
greatly appreciated…
UNSUBSCRIPTION
It’s really not all that involved. First, ask your
Internet Service Provider to mail you an Unsubscribing
Kit. Then follow these directions.
The kit will most likely be the standard no-fault type.
Depending on requirements, System A and/or System B can
be used. When operating System A, depress lever and a
plastic dalkron unsubscriber will be dispensed through
the slot immediately underneath. When you have fastened
the adhesive lip, attach connection marked by the large
“X” outlet hose. Twist the silver-coloured ring one inch
below the connection point until you feel it lock.
The kit is now ready for use. The Cin-Eliminator is
activated by the small switch on the lip. When securing,
twist the ring back to its initial condition, so that
the two orange lines meet. Disconnect. Place the dalkron
unsubscriber in the vacuum receptacle to the rear.
Activate by pressing the blue button.
The controls for System B are located on the opposite
side. The red release switch places the Cin-Eliminator
into position; it can be adjusted manually up or down
by pressing the blue manual release button. The opening
is self-adjusting. To secure after use, press the green
button, which simultaneously activates the evaporator
and returns the Cin-Eliminator to its storage position.
You may log off if the green exit light is on over the
evaporator. If the red light is illuminated, one of the
Cin-Eliminator requirements has not been properly
implemented. Press the “List Guy” call button on the
right of the evaporator. He will secure all facilities
from his control panel.
To use the Auto-Unsub, first undress and place all your
clothes in the clothes rack. Put on the velcro slippers
located in the cabinet immediately below. Enter the
shower, taking the entire kit with you. On the control
panel to your upper right upon entering you will see a
“Shower seal” button. Press to activate. A green light
will then be illuminated immediately below. On the
intensity knob, select the desired setting. Now depress
the Auto-Unsub activation lever. Bathe normally.
The Auto-Unsub will automatically go off after three
minutes unless you activate the “Manual off” override
switch by flipping it up. When you are ready to leave,
press the blue “Shower seal” release button. The door
will open and you may leave. Please remove the velcro
slippers and place them in their container.
If you prefer the ultrasonic log-off mode, press the
indicated blue button. When the twin panels open, pull
forward by rings A & B. The knob to the left, just
below the blue light, has three settings: low, medium
or high. For normal use, the medium setting is suggested.
After these settings have been made, you can activate
the device by switching to the “ON” position the
clearly marked red switch. If during the unsubscribing
operation, you wish to change the settings, place the
“manual off” override switch in the “OFF” position.
You may now make the change and repeat the cycle. When
the green exit light goes on, you may log off and
have lunch. Please close the door behind you.”